SKU: 75-146NC2

The NC-2 unit can directly drive two nitrous stages with progressive control (modulated flow). Features · Drives two nitrous stages and purge solenoid. NC-2 is capable of 40 amp output on each stage. · Each stage is independently programmable based on throttle position, RPM, vehicle speed, time delay, and first gear lockout. NC-2 adds capability for RPM or time based progressive control. · Output for purge solenoid (requires external relay). Programmable automatic purge when system is armed. · Flexible RPM input compatible with high voltage coil drive (vehicles with coil packs or distributor ignition), standard 12 volt tach signal, or low level logic drive (newer vehicles with coil-on-plug). · General purpose input/output (GPIO) terminal. Programmable for use as shift light output, additional stage enable input, or control output for ignition retard. · Status LED output (ideal for use with arming switch containing LED). · Built-in data logging. Ideal as basic vehicle data logger during dyno tuning or drag racing. Logs data whenever system is armed. Stores last 5 minutes of data at 10 samples/second. · Data logged includes throttle position, RPM, vehicle speed, status of all inputs and outputs, and two 0-5 volt analog inputs. · 0-5 Volt analog inputs are compatible with Daytona Sensors single or dual channel WEGO II systems for logging wide-band air/fuel ratio data. · Heavy duty industrial grade clamping terminal blocks allow easy and reliable hookup without soldering or crimping. · NC-2 is 4.1”L x 2.8”W x 1.1”H (not including mounting feet and terminal block). · USB interface to laptop PC. Powerful Windows software for programming controller and downloading logged data. NC-2 DAYTONA TWIN TEC